All our tire covers

These window graphics are easily applied to the outside of any window. Because they are applied to the outside, window tint and window defrosters are not effected and can still be used. These window graphics are easy to see out, but very hard to see in. Protect your valuables (tools, golf clubs, stereo equipment, etc..) from people passing by. Window graphics are available for side windows also, please contact me for more information. Window graphics can also be easily removed.

Your window size is not needed to purchase your window graphic. After you purchase your new window graphic you will receive an email that will explain how to measure your window. This will insure a proper fit. When you have your measurements, simply reply to that email with your window size.

Best Regards, Chris.

Dolphin #1

$59.99

Eagle & Mountains

$59.99

Horse #1

$59.99

Horse #2

$59.99

Horse #3

$59.99

Tropical Sunset #1

$59.99

Deer #1

$59.99

Grizzly Bear

$59.99

How To Measure Your window

For best fit, start by measuring the width of the window, side to side at the widest part of the window. Then measure the height of the window, top to bottom at the tallest part of the window. These measurements will help to ensure an accurate fit. Please do not ad extra, as I will ad an additional 2 inches. Please include the name of the window graphic you ordered, and the last name on the order along with your window measurements. Step by step instructions for easy installation will be included with your window graphic.

Application Instructions

STEP ONE: PREPARE VEHICLE

If possible, bring the vehicle into a heated building. If applying image outside, verify that outside air temperature is not below +40º F (+5ºC). During cold weather, warming up the car interior will improve adhesion.

STEP TWO: CLEAN GLASS

The adhesive performs best when applied to very clean glass. Clean the outside glass where you plan to mount the image with soap and water. The surface must be dry and clear of debris before window image is applied.

STEP THREE: PLACE AND APPLY

Warning: Do not apply with heat gun, water, or any other tools!

Before removing the backing, arrange the graphic on the glass the way you like, using strips of masking tape to keep in place. Starting from one edge, gently peel off backing from behind the image and apply to glass, working towards the reverse side. Smooth the sticker as you go to avoid wrinkles. If wrinkles occur, carefully lift up image to the location of the wrinkle, flatten the wrinkle with your hand, and continue application.

STEP FOUR: BOND AND CROP

Lay the removed backing over the applied sticker. Rub hard with the backing, starting from the center and working towards the sides. This will ensure a strong adhesion. The image will be fully set after 24 hours. Full window graphics will have excess material beyond the edges of the glass. This additional material can be trimmed with a razor blade or similar tool.

PROLONGING THE LIFE OF YOUR IMAGE

For the first week after mounting, do not use power car washes. Avoid using abrasive cleaners on the graphic. Refrain from using snow scrapers on the sticker. Rear wiper blades will wear down image. Treat this image like the painted surface of your car.

REMOVING YOUR IMAGE

Thin scraper devices can be used to take off the perforated film. Start from one corner, then raise up a small area. Manual force can then be used to pull the sticker from the glass. Detachment will be easier with warmer outside temperature. Any residue can be cleaned with glass cleaning liquid or citrus adhesive remover.